GAT INSTALLATION & OPERATION
First, loosen and remove the 4 screws securing the side plate
onto the units body. Remove the side plate. Remove the magazine and
check and clear gun for any shells or live bullets. Always double check
making sure that the gun or weapon is clear of any and all ammunition!
With the barrel pointing in a safe direction, cock the gun and "dry-fire,"
checking to see that the distance of trigger travel is adequate and properly
set. Example: 1/i" is considered short travel and 1/4" is long travel.
The unit comes assembled with the short activator bar which will generally work
on most guns. Place the gun on a flat surface with the left side up,
muzzle pointed to the left, and with the grip pointing down. Install
activator body from the bottom onto the trigger guard. (Fig 1)
Insert and tighten the two bottom screws finger tight and until slightly
separated and away from the trigger. Install the activator bar (Fig. 2)
lip side down for most guns, and lip side up for AK47, variants and others.
(Fig. 3) Install side plate with the four screws provided making sure not
to overtighten! (Fig. 4) Again! Make sure your gun/rifle is unloaded
before inserting your index finger-tip into the thimble of the lever! Make
sure your gun/rifle is unloaded and cock the rifle and insert your index
finger-tip into the thimble of the lever! (Fig. 5) Rotate the handle until
you "dry fire" the rifle. If it doesn't dry fire the gun, move the unit
closer to the trigger or go to the longer activator bar. If the unit "dry
fires" but then tightens up, you must back off the unit away from the trigger
until the unit turns smoothly with a clicking action. Once a smooth
clicker action is achieved, you may tighten the bottom screws forllowed by the
side plate screws. (DO Not Overtighten!) TO FIRE: Simply insert your
finger into the thimble of the lever and rotate it clockwise. Turn lever
smoothly and slowly. Do not jerk the action. When a higher rate of
fire is desired, rotate the lever faster. Very little pressure is required
to operate the device when the unit is installed properly. For single
shots, simply insert your finger onto the guns trigger and fire as normal.
(Fig.6).
Contact: John Rogers
© Extreme Productions.
All rights reserved.